Throttle Cable Installation - Toro TX525 Service Manual

14. Remove the clip securing the throttle cable to the
throttle handle linkage (Fig. 0635).
15. Unhook the throttle cable Z-bend from the throttle
cable handle linkage (Fig. 0636).
TX525 Service Manual
Fig 0635 PICT-7151a
Fig 0636 PICT-7155
16. Remove the throttle cable from the machine.
17. Remove the adjusting nuts from the throttle cable.
Retain them for use on the new throttle cable (Fig.
0637).

Throttle Cable Installation

1. Thread the adjusting nuts onto the throttle cable
approximately half way up the threads leaving a gap
between the two nuts to accommodate the throttle
plate (Fig. 0638).
Rev. 000
ENGINE
Fig 0637 PICT-7158a
Fig 0638 PICT-7158a
4-147