Tensioner Wheel Bearing Installation - Narrow Track - Toro TX525 Service Manual

Tensioner Wheel Bearing Installation -
Narrow Track
Note: The raised inner race of the bearing should
be facing outward on both bearings on the
tensioner wheel (Fig. 1628).
TX525 Service Manual
Fig 1628 CLR DSC-0810
DRIVE SYSTEM
1. Press the first bearing in so the outer bearing race is
flush with the center hub.
2. Turn the tensioner wheel over and install the spacer
centered on the inner race (tensioner wheel bolt can
be used to keep the spacer centered to the bearing
inner race) and press the second bearing in until the
spacer is captured between the bearings.
Important: Press on outer bearing race only, other-
wise bearing damage could occur.
Note: The outer race of each bearing is flush with
the center hub of the tensioner wheel (Fig.
1629).
Rev. 000
Fig 1629 CLR DSC-0811
7-99