Drive System; Lifting The Machine For Service - Toro TX525 Service Manual

Lifting the Machine for Service

1. Place two pieces of approximately 2" (5.08cm) thick
wood blocks directly behind both tracks (Fig. 1261).
2. Back the machine up onto the wood blocks.
3. Place a hydraulic floor jack under the rear frame of
the machine (Fig. 1262).
TX525 Service Manual
Fig 1261 PICT-4245
Fig 1262 PICT-4247

DRIVE SYSTEM

4. Raise the rear of the machine, remove the two wood
blocks and place a jack stand under each corner of
the frame (Fig. 1263).
5. Raise the hydraulic floor jack approximately 15"
(38.10cm) and position it at the front of the machine
(Fig. 1264).
Rev. 000
Fig 1263 PICT-4248
Fig 1264 PICT-4249
7-1