Lift Cylinder Disassembly - Toro TX525 Service Manual

HYDRAULIC SYSTEM
INSPECT TUBE ASSEMBLY: Visually inspect the
inside bore for scratches and pits. There should
be no scratches or pits deep enough to catch the
fingernail. Scratches that catch the fingernail but
are less than 0.5" long (1.27cm) and primarily in the
circumferential direction are acceptable provided
they cannot cut the piston seal. In the event that an
unacceptable condition occurs, the cylinder should
be replaced (Fig. 1196).
A
C D
A. Barrel
B. Retaining Ring
C. Piston
6-96
E
Fig 1196 PICT-3039a
D. Head
E. Ram

Lift Cylinder Disassembly

1. Remove the wear ring from the piston (Fig. 1197).
B
2. Remove the piston seal from the ram assembly (Fig.
1198).
Rev. 000
Fig 1197 PICT-3040
Fig 1198 PICT-3041a
TX525 Service Manual