Starter Solenoid Installation - Toro TX525 Service Manual

18. Remove the grounding wire (Fig. 0294).
19. Using a 10mm socket, remove the 2 flange nuts
securing the solenoid to the starter assembly (Fig.
0295).
TX525 Service Manual
Fig 0294 PICT-5216a
Fig 0295 PICT-5217a
20. Remove the starter solenoid assembly (Fig. 0296).

Starter Solenoid Installation

1. Position the starter solenoid assembly to the starter
assembly. Ensure the joint of the solenoid switch is
engaged into the drive lever (Fig. 0297).
B
A
A. Solenoid switch joint
Rev. 000
ENGINE
Fig 0296 PICT-5218a
Fig 0297 PICT-5221a
B. Drive lever
4-59