Spool Assembly - Toro TX525 Service Manual

22. Remove the two o-rings located at the bottom of the
valve; a small dental pick works to help remove the
o-rings (Fig. 1147).

Spool Assembly

Replace all seals and o-rings with new parts. Lubricate
the valve, o-rings, and spool with 10W-30 oil prior to
installation (Fig. 1148).
C D
A B
H
I
A. Spring Cap
B. Tilt Spring
C. O-ring (2)
D. Valve Body
E. Tilt Spool
TX525 Service Manual
Fig 1147 PICT-2626
E
G
Fig 1148 PICT-2629
F. Spool Valve Seal (2)
G. Lift Spool
H. Detent Spring
I. Detent Cap
HYDRAULIC SYSTEM
1. Lubricate the two o-rings located at the bottom of the
valve and install (Fig. 1149).
2. Lubricate and install the spool valve seals in the top
of the valve (Fig. 1150).
Note: The thin wall of the seal goes into the valve
body first.
F
Rev. 000
Fig 1149 PICT-2630
Fig 1150 PICT-2631
6-83