Spool Removal - Toro TX525 Service Manual

10. Position the rubber bellows over the base plate
and install the tie strap in the groove of the rubber
bellows (Fig. 1123).
Note: When installing the rubber bellows, there
is an offset in the bellows. Ensure proper
installation.
11. Install the lift/tilt handle (Fig. 1124).
TX525 Service Manual
Fig 1123 PICT-2605a
Fig 1124
PICT-2584a
HYDRAULIC SYSTEM

Spool Removal

Note: To disassemble and assemble the valve, it is
best to hold the valve in a bench vise.
1. Remove the cable tie from around the rubber
bellows (Fig. 1125).
2. Remove the rubber bellows from the valve assembly
(Fig. 1126). Wipe the excess grease from the
joystick.
Rev. 000
Fig 1125 PICT-2588a
Fig 1126 PICT-2589a
6-77