Wheel Motor Installation - Toro TX525 Service Manual

DRIVE SYSTEM
25. Rotate the wheel motor 90° so the ports are facing
upward, this will allow the raised portion of the wheel
motor to fit through the notch in the frame. Remove
the wheel motor (Fig. 1497).
26. For wheel motor service, Refer to the Parker / Ross
Wheel Motor Service Manual (Toro p/n: 492-4753).
7-62
Fig 1497 PICT-4466

Wheel Motor Installation

1. Insert the wheel motor into the frame with the
ports facing up. After the wheel motor is inside the
frame, rotate the wheel motor 90° clockwise so the
hydraulic ports are facing to the rear (Fig. 1498).
2. Wheel motor mounting plates have a wide side and
narrow side. The wide side faces up when installing
the wheel motor (Fig. 1499).
B
A. Wide Side
Rev. 000
Fig 1498 PICT-4471
A
Fig 1499 PICT-4473a
B. Narrow Side
TX525 Service Manual