Coupling Installation - Toro TX525 Service Manual

HYDRAULIC SYSTEM
3. Secure the flywheel to keep it from turning. You
can do this by sliding a length of 5/16" diameter rod
stock in between the fan mount pulley and fan mount
spacer. The rod stock should be inserted so it runs
on top of the fan mount pulley screw. The rod stock
should be at least 16" long so that it rests on the left
hand loader arm lift cylinder (Fig. 0904).
4. Remove the 4 bolts securing the hub sleeve to the
flywheel (Fig. 0905).
6-20
Fig 0904 PICT-4840
Fig 0905 PICT-4863
5. Remove the hub sleeve (Fig. 0906).

Coupling Installation

1. Raise the hood and remove the left side grill (Fig.
0907).
Rev. 000
Fig 0906 PICT-4828a
Fig 0907 PICT-6962a
TX525 Service Manual