Hydraulic Reservoir Tank; Location; Checking The Hydraulic Fluid - Toro TX525 Service Manual

MAINTENANCE MAINTENANCE

Hydraulic Reservoir Tank

Location

The hydraulic reservoir tank is located in the front of the
TX525 unit.
Hydraulic Tank Capacity: 10.5 gallons (39.7 liters)
Type of Oil to Use: 10w-30 or 15w-40 detergent, diesel
engine oil (API Service CH-4 or higher).

Checking the Hydraulic Fluid

Check the hydraulic fluid level daily before the engine is
first started and after every 25 operating hours.
1. Remove the attachment, if one is installed.
2. Park the traction unit on a level surface, open the
hood, raise the loader arm, install cylinder lock and
fully retract the tilt cylinder.
3. Stop the engine, remove the key, and and allow the
engine to cool.
4. Remove the LH side grill.
5. Clean the area around the filler neck of the hydraulic
tank (Fig. 0007).
3-4
Fig 0007 PICT-8731
6. Remove the cap from the filler neck and check the
fluid level on the dipstick (Fig. 0008).
7. The fluid level should be between the marks on the
dipstick. If the level is low, add enough fluid to raise
it to the proper level.
8. Install the cap on the filler neck.
9. Install the RH side grill.
10. Start the unit, remove the cylinder lock and lower the
loader arms.
11. Close the hood.
Rev. 000
Fig 0008 PICT-8738
TX525 Service Manual