Narrow Track Installation - Toro TX525 Service Manual

6. Push the tension wheel toward the rear of the unit to
move the tension arm against the frame (Fig. 1535).
(If it does not touch the frame, continue turning the
tensioning screw until it does.)
7. Begin removing the track at the top of the tension
wheel, prying it off of the wheel while rotating the
track forwards (Fig. 1536).
TX525 Service Manual
Fig 1535 PICT-5342
Fig 1536 PICT-5344
DRIVE SYSTEM
8. When the track is off of the tension wheel, remove it
from the road wheel and drive sprocket (Fig. 1537).

Narrow Track Installation

Important: Before installing the track, use the
Alignment Tool Toro P/N 110-0069 for proper
alignment between the drive sprocket and the
front tension wheel. Refer to "Track Guide
Alignment" on page 7-3.
1. Beginning at the drive sprocket, coil the track around
the sprocket, ensuring that the lugs on the track fit
between the spacers on the sprocket (Fig. 1538).
Rev. 000
Fig 1537 PICT-5346
Fig 1538 PICT-5345
7-73