Throttle Cable Adjustment - Toro TX525 Service Manual

ENGINE

Throttle Cable Adjustment

1. Raise the hood.
2. Remove the right hand side panel (Fig. 0617).
3. Move the air intake hose out of the way of the
throttle plate. Using a 1/4" wrench, loosen the
throttle cable swivel (Fig. 0618).
4-142
Fig 0617 PICT-8759
Fig 0618
PICT-7140
4. There should be approximately 3/16" to 1/4" (0.48 to
0.635cm) of cable through the swivel (Fig. 0619).
5. To adjust the amount of cable going through the
swivel (Fig. 0620):
a. Using two 7/16" wrenches, loosen the two
adjusting nuts securing the cable to the throttle
bracket.
b. To shorten the cable: thread the nuts toward the
cable end.
c. To lengthen the cable, thread the nuts further
onto the cable.
Rev. 000
Fig 0619
PICT-7107
Fig 0620 PICT-7113
TX525 Service Manual