Ford 2003 Mustang Workshop Manual page 3483

SECTION 417-01: Exterior Lighting
REMOVAL AND INSTALLATION
Lamp Assembly —Fog Lamp (GT)
Removal
1. Raise and support the vehicle.
2. Remove the screw.
3. Partially lower the vehicle and remove the fog lamp assembly.
1. Disconnect the electrical connector.
2. Remove the two screws.
3. Remove the fog lamp assembly and replace the bulb if necessary.
Installation
1. NOTE: Be sure the fascia clip is correctly installed on the bottom side of the fog lamp assembly
bracket.
To install, reverse the removal procedure.
2003 Mustang Workshop Manual