Ford 2003 Mustang Workshop Manual page 3876

(LB/OG) FOR SHORT TO GROUND BETWEEN THE GEM AND
THE MULTIFUNCTION SWITCH
Key in OFF position.
Using the following table, measure the resistance between
the GEM C201e Pins, harness side and ground.
Pin Circuit
5 682 (DB)
18 684 (PK/YE)
19 680 (LB/OG)
Are the resistances greater than 10,000 ohms?
B9 CHECK CIRCUITS 682 (DB), 684 (PK/YE), AND 680
(LB/OG) FOR AN OPEN CONDITION BETWEEN GEM AND
MULTIFUNCTION SWITCH
Using the following table, measure the resistance between
the GEM C201e Pins, harness side and multifunction
switch C202a Pins, harness side.
GEM Multifunction Switch
C260 Pin 5
C260 Pin 18
C260 Pin 19
Are the resistances less than 5 ohms?
B10 CHECK CIRCUITS 65 (DG) FOR OPEN CIRCUIT
CONDITION BETWEEN BJB AND CJB
NOTE: Verify voltage at CJB F26 (30A) before carrying out
this test.
Disconnect: Wiper On/Off Relay.
Measure the voltage between BJB ON and OFF wiper
Circuit
C202a Pin 685 682 (DB)
C202a Pin 590 684 (PK/YE)
C202a Pin 993 680 (LB/OG)
Yes
REPAIR the circuit(s) in
question. REPEAT the self-
test. CLEAR the DTCs.
No
GO to B9 .
Yes
INSTALL a new GEM. For
additional information,
REFER to Section 419-10
REPEAT the self-test.
CLEAR the DTCs.
No
REPAIR circuit(s) in question.
REPEAT the self-test.
CLEAR the DTCs.
Yes
GO to B11 .
No
.