Ford 2003 Mustang Workshop Manual page 3891

SECTION 501-16: Wipers and Washers
REMOVAL AND INSTALLATION
Mounting Arm and Pivot Shaft
Removal
1. Park the windshield wipers in the full upright position. This will allow for easy access to the
retaining clip on the wiper motor output shaft.
2. Remove the cowl top vent panels.
3. Disconnect the battery ground cable.
4. Disconnect the mounting arm and pivot shaft linkage from the wiper motor output shaft.
1. Remove the clip.
2. Disconnect the mounting arm and pivot shaft linkage from the wiper motor output shaft.
5. NOTE: It is necessary to lower the hood to remove the mounting arm and pivot shaft.
Remove the mounting arm and pivot shaft.
1. Remove the bolts.
2. Remove the mounting arm and pivot shaft through the RH cowl chamber opening.
2003 Mustang Workshop Manual