Ford 2003 Mustang Workshop Manual page 3922

If one rod bottoms out 25mm (1 inch) or more before the other, the lagging lift cylinder may be
bent and will need to be replaced.
16. With the lift cylinder rods retracted, manually lower the convertible top.
17. Manually lift each side rail 7.5-10 cm (3-4 inches) to check for obvious binding. Side arms
should have equal resistance, side-to-side. If the resistance is noted, loosen the clamp load of
the c-pivot rivet with using a center pinch. If a dramatic resistance is still noted replace the c-
pivot rivet with shoulder bolt kit (F5ZZ-76539A04-A).
18. Position the lift cylinders and install the nuts.
19. Install the two cylinder rod mounting bolts.
20. Install the speakers. For additional information, refer to
21. Install the screws.
NOTE: This step applies to vehicles equipped with the Mach sound system.
22. Install the screws and connect the electrical connectors.
Section 415-03 .