Ford 2003 Mustang Workshop Manual page 3784

3. Using a wool applicator, apply the Urethane Metal Primer Essex U-413 meeting Ford
specification WSB-M2G234-C to any exposed metal on the pinch weld. Allow 6 to 10 minutes to
dry.
4. If reinstalling the original windshield glass, remove the excess urethane adhesive from the
windshield glass.
5. If installing a new windshield glass, clean the inside of the glass surface with an alcohol-free
cleaner to make sure the ceramic-coated area is clean.
6. CAUTION: Wipe off the urethane glass prep immediately after each application
because it flash dries. Apply deliberate strokes, making sure not to overlap the applied
area.
If installing a new windshield glass, apply Urethane Glass Prep Essex U-401 meeting Ford
specification WSB-M2G314-B twice around the class surface to be prepped.
7. If installing a new windshield glass, apply Urethane Glass Primer Essex U-402 meeting Ford
specification WSB-M5B280-C to the same area that was in the previous step. Allow five minutes
to dry.
8. Cut the applicator tip to specification.
9. CAUTION: If the vehicle is to be driven within 24 hours of urethane adhesive
application, Urethane Adhesive Essex U-216 meeting Ford specification WSB-M2G316-B
must be used due to its one hour cure time.
Apply a bead of Urethane Adhesive Essex 400-HV or Essex U-216 meeting Ford specification
WSB-M2G316-B to the pinch weld.