Installation
1. NOTE: Install the retaining clip onto the mounting arm and pivot shaft linkage prior to the
installation of the wiper motor.
Install the wiper motor
1. Install the bolts.
2. Connect the electrical connector.
2. Snap the mounting arm and pivot shaft linkage onto the wiper motor output shaft.
3. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms
may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven
16 km (10 miles) or more to relearn the strategy.
Reconnect the negative battery cable.
4. Cycle the wiper motor to the park position.
5. Install the cowl top vent panels.
Adjust pivot arms as necessary. Refer to
Wiper Blade and Pivot Arm Adjustment
.