Ford 2003 Mustang Workshop Manual page 3385

SECTION 414-02: Generator and Regulator
REMOVAL AND INSTALLATION
Generator —3.8L
Removal and Installation
1. Disconnect the battery (10655). For additional information, refer to
2. Relieve the accessory drive belt (8620) tension and remove the belt from the generator pulley.
Leave the belt in place for reinstallation. For additional information, refer to
3. CAUTION: This is a new style connector that has a press-to-release tab. Pulling on
the tab could result in damage to the connector or harness.
Disconnect the generator (10300).
1. Disconnect the generator electrical connectors.
2. Remove the battery positive cable nut.
4. Remove the generator.
Remove the upper and lower generator bolts.
5. To install, reverse the removal procedure.
2003 Mustang Workshop Manual
Section 414-01
Section 303-05
.
.