Ford 2003 Mustang Workshop Manual page 3572

SECTION 419-01: Anti-Theft — PATS
GENERAL PROCEDURES
Key Programming —Erase All Key Codes and Program Two
Keys
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052 or equivalent
diagnostic tool
NOTE: This procedure is used when a customer needs keys programmed into the system and does
not have two programmed ignition keys available. This procedure is also useful when programmed
ignition key(s) have been lost or the ignition switch assembly has been replaced, and it is desired to
erase key(s) from the passive anti-theft system (PATS) memory.
NOTE: This procedure will erase all programmed ignition keys from the vehicle memory and the
vehicle will not start until two keys have been reprogrammed to the vehicle.
NOTE: Two PATS encoded keys with the correct mechanical cut must be available to perform this
procedure. One or both of them may be the customer's original keys.
NOTE: If additional keys are to be programmed, refer to Key Programming — Program a Key Using
Two Programmed Keys. If the remaining keys are with the customer and are not available with the
vehicle, then instruct the customer to refer to the Owners Guide under the "Programming Spare
[SecuriLock ® (North America), Safeguard ® (U.K.) or PATS for all other markets] Keys Procedure" for
instructions on programming the remaining keys.
1. Turn the ignition switch from OFF to RUN.
2. Enter diagnostic tool. Follow the SECURITY ACCESS PROCEDURE to obtain security access.
3. From diagnostic tool menu, select IGNITION KEY CODE ERASE.
4. NOTE: Do NOT select any additional commands from this menu.
Turn the ignition switch to OFF and disconnect diagnostic tool.
5. Insert the first encoded key into the ignition lock cylinder and turn the switch to RUN for three
seconds.
6. Insert the second encoded key into the ignition lock cylinder and turn the switch to RUN for
three seconds.
7. The vehicle should now start with both ignition keys.
2003 Mustang Workshop Manual