Ford 2003 Mustang Workshop Manual page 3761

7. Using the special tool, distance the back window glass from the body.
8. Using the special tool, cut the remaining urethane adhesive and remove the back window glass
9. Using a soft brush or vacuum, clean the pinch weld.
Installation
Convertible
1. For installation of the back window glass, refer to
Coupe
CAUTION: After installing the urethane installed back window glass, the vehicle should
not be driven until the urethane adhesive has cured. The curing time at temperatures above 13°
C (55°F) and relative humidity above 50% is 12-24 hours (Refer to ESSEX drive away chart for
cure times as temperatures and humidity vary.). Inadequate curing of the urethane adhesive
may adversely affect the strength of the urethane adhesive bond.
2. Dry-fit the back window glass by centering it side-to-side and by adjusting the setting blocks (if
equipped) to get the correct position of the part top-to-bottom. Make alignment marks with tape
Section 501-18 .