Ford 2003 Mustang Workshop Manual page 3268

Odometer
Display
GAGE Activates gauge sweep of all gauges, then displays present gauge values. Also
All segments
illuminated
bulb Illuminates all micro-controlled indicators and LEDs. Install a new indicator or LED as
r Returns to normal operation of all micro-controlled indicators and LEDs and displays
hexadecimal value for ROM level (used when requesting assistance from the hotline).
EE Displays hexadecimal value for EE level (used when requesting assistance from the
dt Displays hexadecimal coding of final manufacturing test date (used when requesting
dtc Displays continuous DTCs in hexadecimal format. Pressing the SELECT/RESET
button will display any DTCs stored before proceeding to the next step.
enG Displays the English speed in mph. Speedometer will indicate present speed within
tolerances. Display will show 0 if input is not received, if input received is invalid for
m Displays the metric speed data (km/h). Speedometer will indicate present speed
within tolerances. Display will show 0 if input is not received, if input received is invalid
tAc Displays the tachometer data received from the PCM via the SCP network within
tolerances. Tachometer will indicate present rpm. Display will show 0 if input is not
received, if input received is invalid for one second or more, or if engine rpm is 0.
FUEL Displays the code (0-255) for the fuel sender input to the instrument cluster. The fuel
gauge will display a filtered fuel level value. This filter will keep the pointer from
OIL Displays the code (0-250) for the oil pressure switch input to the instrument cluster.
Oil pressure gauge will indicate present oil pressure. Normal oil pressure (greater
than 6 psi) will display a value between 000 and 176. A low oil pressure or an
inoperative engine oil pressure switch (less than 6 psi) will display a value greater
dEGC Display of engine temperature in degrees C input from cylinder head temperature
bAtt Displays the code (0-255) for the battery voltage input to the instrument cluster.
carries out the checksum tests on ROM and EE.
Illuminates all odometer segments.
assistance from the hotline).
one second or more, or if speed is 0.
for one second or more, or if speed is 0.
moving suddenly or erratically.
255 = open send +/- 0
215 = full mark +/- 10
178 = 3/4 mark +/- 8
138 = 1/2 mark +/- 7
54=LOW FUEL (0-59)
0-18=short (0-20 max)
60 C = normal band start
120 C = normal band end
-40 C = no SCP message for 5 seconds
Battery voltage gauge will indicate present battery voltage.
Description
necessary.
hotline).
232 = full stop +/- 0
93 = 1/4 mark +/- 5
41 = E mark +/- 4
than 176.
sensor.
49 C = "C" mark