Recording The Call Duration; Output On Ringing; Changing The Charge Factor - Siemens Hicom 100 E Service Manual

Programming guide
System settings
10.7.15.4

Recording the call duration

If incoming calls are output in the data record, the call duration before the call is answered is
also output. Output of the call duration can be deactivated if required.
Example: the call duration is not to be output.
Input sequence
A 1 1 3 4
B *
C 0
D <OK>
E <F8>
The call duration output can be activated by entering "1" under point C.
10.7.15.5

Output on ringing

If incoming calls are output in the data record, each call received is logged in the data record
as an additional information line. Output can be deactivated if you do not want this information
line to be logged.
Example: the information line for incoming calls is not to be logged (SW 2.0.2 only).
Input sequence
A 1 1 3 5 (up to SW2.0.2)
11 7 (as of SW2.1)
*
B
C 0
D <OK>
E <F8>
Output of the information line is activated by entering "1" under point C.
10.7.15.6

Changing the charge factor

The charge factor is set to "5" by default (to "12" as of SW version 2.0.1+).
It can be changed to any value up to 65535.
10-74
Meaning
Call duration output
Change input
No call duration output
Confirm input
Return to Start menu
Meaning
on ringing
Change input
Do not output information line
Confirm input
Return to Start menu
Display
Output: yes
Output:
Output: no
Output: no
System administration
Output: yes
Output:
Output: no
Output: no
System administration
A31003-K16-X001-3-7620
Hicom 100 E Version 2.1, Service manual
Display
,
07/99