Table of Contents
Advertisement
Are the SCSI controllers properly configured?
- Use the SCSI configuration utility for proper configuration of SCSI devices
connected to the optional SCSI controller. See the manual that comes with the
optional SCSI controller for details.
Problems with Windows Server 2003
When network cable isn't connected with a port, the following log may be found in
event log.
But this has no affect on the behavior of LAN driver.
Event ID:
Source:
Type:
Description: Hardware failure detected.
Machine:
Lan:
Solution:
Problems with Windows 2000
Cannot install the operating system correctly.
Did you confirm the notes on installing the operating system?
- See
"Microsoft Windows 2000" on page D-20
During Windows 2000 installation, the following warning is registered in the System
Log of the Event Viewer:
- There is no problem on this issue.
Fail to start the OS:
Is a floppy disk in the floppy disk drive?
- Take out the floppy disk and restart the server.
Is the NEC EXPRESSBUILDER CD-ROM in the CD-ROM drive?
- Take out the NEC EXPRESSBUILDER CD-ROM and restart the server.
120Eg User Guide - Problem Solving
6
E100B
Error
Express5800/<Your Model Name>
100BASE
Connect a network cable in a port and then reboot the system or
change the [Smart Power Down] value to "Off", the log will not
be found in event log any more.
Error detected on the device \Device\CdRom0
during the paging operation.
5 - 25
.
Advertisement
Table of Contents
