Moving System Board Jumpers
Before doing the procedures in this section, make sure that your
system is powered off and unplug the AC power cords from the
back of the chassis. Failure to disconnect power before moving
the jumpers can result in personal injury and equipment
damage.
Observe static precautions. Use an antistatic wrist strap.
120Eg User Guide - Configuring Your System
A
B
D
A
B
CMOS jumper - Normal (factory setting)
C
CMOS jumper - Clear CMOS
D
Password jumper - Normal (factory setting)
E
Password jumper - Clear password
Figure 3 - 1: CMOS and Password Jumpers
Caution
A
A
C
Not used
3 - 28
A
E