Table of Contents
Advertisement
4. Follow the message to continue the installation.
If the dialog message "Digital Signature could not been found." appears, select
[Yes] to continue.
5. Remove the NEC EXPRESSBUILDER CD-ROM from the CD-ROM drive,
follow the direction on the screen and restart the system.
USB 2.0 Driver
USB 2.0 Driver is pre-installed.
When restoring the system or re-installing the system, the driver is automatically
installed in the process of updating the system.
Installing SCSI Controller Driver
If you utilize SCSI controller driver (INITIO INI-A10XU2W PCI SCSI Controller /
Adaptec SCSI Card 29320ALP -Ultra320 SCSI), install it according to the following
procedure:
1. Start [Device Manager] from [Start] menu → [Control Panel]→
[Administrative Tools] → [Computer Management].
2. Double click the SCSI Controller driver which Device Manager lists as
unknown device.
3. Click [Update Driver].
4. When the "Update Device Driver Wizard" appears, select "Display a list of the
known drivers for this device so that I can choose a specific driver" and click
[Next].
5. Select [SCSI and RAID controllers], Click [Have Disk..].
6. Insert "Windows 2000 OEM-DISK for NEC EXPRESSBUILDER" into the
floppy disk drive, enter "a:\" into "copy manufacturer's file from:" and click
[OK].
7. Specify the following driver and click [Next].
[INITIO INI-A10XU2W PCI SCSI Controller] (When board is installed.)
[Adaptec SCSI Card 29320ALP -Ultra320 SCSI] (When board is installed.)
The installation of the driver is completed.
Restart the system according to the message appeared on the screen.
Setting for Solving Problems
Setup the following issue in advance so that your computer can recover from any
trouble precisely and as soon as possible when it should occur.
120Eg User Guide - Appendix D
D - 30
Advertisement
Table of Contents
