Table of Contents
Advertisement
13. Connect the interface and power cables to the drive.
For serial ATA hard disk drives, use the relay cable connector
that comes within your server or with the optional S-ATA con-
troller as shown figure below.
14. Reinstall the left-hand side access panel on the system chassis. See
or Installing the Side Cover" on page 4-4
15. Plug in the system power cord(s), and turn on the system.
Swapping a Hard Disk Drive
1. Observe the safety and ESD precautions listed under
and
xviii
2. Prepare your system for upgrade. See
page 4-3
3. Remove the left-hand side access panel as described in
the Side Cover" on page 4-4
Observe static precautions. Use an antistatic wrist strap.
4. Disconnect the interface and power cables attached to the drive.
5. Remove the disk carrier tray from the bay. The disk carrier tray is released by
removing the two screws holding it in place (see "Figure 4 - 11: Releasing the
Disk Carrier Tray" on page 4-17).
120Eg User Guide - Upgrading Your System
Caution
"Static Precautions" on page 4-2
.
.
Caution
.
.
"Preparing Your System for Upgrade" on
4 - 20
"Removing
"Safety Notices" on page 1-
"Removing or Installing
Advertisement
Table of Contents
