Table of Contents
Advertisement
3. Hold the tray and pull it out.
4. Take out the CD-ROM.
5. Push the tray back into position.
Use of the CD-ROM
Keep the following notes in mind to use the CD-ROM for the server:
For the disk which does not conform to the CD standard, the playback of such a
disk with the CD drive is not guaranteed.
Do not drop the CD-ROM.
Do not place anything on the CD-ROM or bend the CD-ROM.
Do not attach any label onto the CD-ROM.
Do not touch the signal side (nothing is printed on this side) with your hand.
Place the CD-ROM with its printed side upward and gently put it on the tray.
Do not scratch the CD-ROM or write anything directly on it with a pencil or ball-
point pen.
Keep the CD-ROM away from cigarette smoke.
Do not leave the CD-ROM in a high-temperature place (e.g., place exposed to
direct sunlight or close to a heater).
When dust or fingerprints are attached on the CD-ROM, wipe the CD-ROM from
its center to edge with a dry soft cloth slowly and gently.
Use the CD cleaner to clean the CD-ROM. Do not use record spray/cleaner,
benzene, or thinner.
Keep the CD-ROM in a CD-ROM case when not in use.
If the CD-ROM emits large noise in the CD-ROM drive, remove the CD-ROM and
insert it back again.
120Eg User Guide - Setting Up the System
2 - 20
Advertisement
Table of Contents
