Dos-Based Expressbuilder Menus - NEC Express 5800 120Eg User Manual

DOS-Based ExpressBuilder Menus

Express Setup
"Express Setup" is intended for initial setup of the server. Its automatic installation
mode guides the user easily through the process by detailing specific hardware features
and providing screen prompts for software selection and configuration. The program
loads the utilities and drivers, applies RAID settings, partitions the disk, and installs the
desired operating system.
If you install Windows Server 2003 or Windows 2000 Server, after a few tasks are
completed, all that remains to be done is to remove the NEC EXPRESSBUILDER CD-
ROM and install the Windows CD-ROM, input a product ID number, and acknowledge
the license agreement.
Tools
"Tools" is also intended for initial setup of the server. It allows the user to quickly
create utility support disks, run the Off-line Maintenance Utility and system diagnostic
utility, set up a maintenance partition, and update the various BIOS programs.
NEC Express5800 NEC EXPRESSBUILDER Ver3. xxxx-x Copyright (C) NEC Corporation 2004
Tools Menu
Save/Restore RAID Configuration Data
Off-line Maintenance Utility
System Diagnostics
Create Support Disk
Setup Maintenance Partition
BIOS/FW/etc. Update
System Management
Help
Return to the Top Menu
Save/Restore RAID Configuration Data
The item allows the configuration information on the disk array system to be saved
or restored from the floppy disk.
120Eg User Guide - Appendix E
The Express Setup is intended for the initial setup of the
server system and, therefore, the Express Setup clears the
contents of the hard disk.
Once Express setup is started, do not remove "Configuration
Diskette" from the floppy disk drive without any directions.
Caution
RAID Board: Present
Total Drives: 1
Drives in Group: 1
Hot Spares: 1
RAID Level: 7
Write Mode: WRITE_THRU
Maint Part: Present
E - 4