Table of Contents
Advertisement
Installing the Windows Server 2003
This section describes on how to setup the system using Express Setup.
Prepare Configuration Diskette. You can operate the installation if you do not have
Configuration Diskette specified in advance, but one floppy disk formatted by MS-
DOS 1.44 MB is necessary also in such case. For Configuration Diskette, use the blank
disk in NEC EXPRESSBUILDER package or prepare other floppy disk personally.
1. Turn the power of peripheral device on, and then turn on the server.
2. Insert NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive of the
server.
3. Ensure that the floppy disk drive is empty.
4. Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the NEC
EXPRESSBUILDER. (You may also turn off and then on again to reboot the
server.)
The system will boot from the CD-ROM and NEC EXPRESSBUILDER
starts.
5. Click [Express Setup].
"Note" will be displayed.
6. Read the instruction carefully and click [OK].
The message "Insert Configuration Diskette" appears.
120Eg User Guide - Appendix D
If you modified the system configuration, execute "System
Update".
If you want to modify or add Graphics Accelerator Driver or
the drivers of Network Adapter and so on, see Appendix D.
Notes:
If you operate installing Windows Server 2003 with MO
device connected, the installation may not be completed
normally. In such case, detach MO device and then re-install
the system from the beginning.
Connect the hard disk drive that OS is not going to be
installed after installing OS.
If you create multiple logical drives in your system, refer to
"Re-installing the operation system when multiple logical
drives exist" (Appendix D).
Caution
D - 8
Advertisement
Table of Contents
