Table of Contents
Advertisement
120Eg User Guide - Upgrading Your System
4. Remove the four screws that hold the air baffle to the carrier and remove the air
baffle. See "Figure 4 - 20: Removing the Air Baffle" on page 4-27. Save the air
baffle for future use.
A
C
Figure 4 - 20: Removing the Air Baffle
5. Remove the device from its protective wrapper and place it on an antistatic
surface. Record the drive model and serial number in the equipment log.
Observe static precautions. Use an antistatic wrist strap.
6. Set any drive jumpers or switches before you install the drive. See the
documentation that comes with the device for jumper or switch information.
7. Place the drive into the disk carrier removed in steps 3 and 4 above. Orient the
drive so that its component side is down and its data connector is facing the
rear of the carrier. The connector should be flush with the rear of the carrier.
See "Figure 4 - 21: Installing a Hard Disk Drive into the Carrier" on page 4-28.
Note:
If the drive comes with drive rails, do not use them.
Remove any rails already attached.
A
Air baffle
B
Screws (4)
C
Drive carrier
Caution
4 - 27
B
Advertisement
Table of Contents
