Select [Use Existing Array] At [New/Existing Raid Configuration], But The Os Is Installed In The Whole Area Of The Disk; Specified To Join The Domain, But The System Is Installed As Workgroup; Specified Large Value As Partition Size, But When Windows 2000 Is Actually Started, The System Partition Is Created By 4095 Mb; Windows 2000 Started With Different Display Resolution From The Specified Value - NEC Express 5800 120Eg User Manual

Select [Use Existing Array] at [New/Existing RAID Configuration], but the OS is
installed in the whole area of the disk.
- Is there any other partition than the partition to re-use (excluding maintenance
area)? If the partition other than the one to re-use does not exist, the setup will
reserve the whole area of the disk to install Windows 2000.

Specified to join the Domain, but the system is installed as Workgroup.

- When the setup fails to join the Domain during the installation, it will install the
system as Workgroup. Open [System] in Control Panel to specify joining the
Domain.
Specified large value as partition size, but when Windows 2000 is actually started,
the system partition is created by 4095 MB.
- Is the [Partition Size] specified by the value larger than the real area? If you
want to create one partition in all area of the hard disk (excluding the mainte-
nance area) to install the OS, specify [All Area].
- Are you specifying over 200 GB for the partition size?
Be sure to specify less than 200 GB for the partition size.

Windows 2000 started with different display resolution from the specified value.

- If the specified display resolution can not be used, the system will use the near-
est value or the default value of the driver.

Entered the incorrect Product ID/CD key.

- Even if you entered the incorrect Product ID/CD key, Express Setup will start.
However, the setup will stop and asks you to re-enter the correct value. Also in
this case, input request will occur when rebooting after GUI setup completed
during Express Setup. If these 2 inputs are done correctly, there is no problem
on Windows 2000 setup.
The following message appears on the screen and the setup is suspended while
the Express Setup is executing:
- Follow the procedure described below and check the BIOS settings for the SCSI
controller.
As for the procedure on the SCSI controller which is not described in this User's
Guide, refer to the manual accompanied with the controller and check the set-
ting for "Int13 Extensions".
<In case the SCSI Controller is AIC-7892>
1. Press Ctrl + A when POST displays "AIC-7892".
2. Select "Configure/View Host Adapter Settings".
120Eg User Guide - Problem Solving
Bad Command or filename
Insufficient disk space
5 - 29