Table of Contents
Advertisement
Power Lamp (Redundant hot swap system)
The DC power lamp is on (green) when power is applied to the server and the power
button is on. It is off if power is not applied to the server (power cord not connected). It
flashes green when power cord is connected to the AC inlet and the power button is off.
Power Status Lamp (Redundant hot swap system)
The power status lamp is off when the server is operating normally. It flashes amber
when the power supply is faulty.
Hard Disk Drive Lamp
The disk lamp (A in figure below) on the 3.5-inch hard disk drive bay has different
meanings depending on the display status.
Lighting green
Indicates that the power is supplied to the hard disk.
Blinking green
Indicates that the hard disk is accessed.
Lighting amber
Indicates that the installed hard disk is defected in the disk array configuration.
(RAID1 or RAID5), a single failed hard disk does not affect the
operation of the server. However, it is recommended to replace
the failed hard disk and auto-rebuild (reconfigure) the hard
disks as soon as possible. (You can hot-swap such a failed
hard disk.)
120Eg User Guide - Appendix B
Note: While hard disks are in the disk array configuration
A
5 - 49
Advertisement
Table of Contents
