Table of Contents
Advertisement
Category:
Description: Team #0: The last adapter has lost link.
Event ID:
Source:
Type:
Category:
Description: Adapter link down: Intel(R) 82546EB Based Dual Port Network
Connect...
- Though the above error is included in the event log when specifying the team-
ing, the LAN driver can work properly.
Error Message during Disk Array Configuration
When an error is detected during the automatic Disk Array Configuration of the Easy
Setup process, any of the following messages appears.
An illegal device status exists in the status table.
An illegal status is returned during the Configuration Data read.
Configured device(s) is not responding.
The configuration in NvRAM does not agree with the configuration in EEPROM.
The number of pack configuring disks is 0 or 9 or above.
An error occurs during the configuration table read.
The configuration table in NvRAM cannot be read.
An illegal RAID level exists in the configuration table.
An error occurs during the CONFIG2 table transfer.
The adapter is not responding.
A CONFIG2 checksum error occurred.
Adapter does not exists.
When one of above messages is observed, the Disk Array controller or the hard disk
drive may be failed. Check that cable connections and switch settings are correct, and
then attempt to run NEC EXPRESSBUILDER once again.
Problems with Master Control Menu
The master control menu fails to appear:
Is your system Windows NT 4.0 or later, or Windows 95 or later?
120Eg User Guide - Problem Solving
None
Network connection has been lost.
11
iANSMiniport
Warning
None
5 - 31
Advertisement
Table of Contents
