Table of Contents
Advertisement
Your system may include hot-swap S-ATA hard disk drive bays for mounting up to
four hot-swap disk drives in easily removable drive carriers. Each drive carrier has
one lamp to indicate the fault or other status: power-on (green lamp), activity
(flashing green lamp), fault (yellow lamp).
Your system may include hard disk drive bays for installing up to four S-ATA or
SCSI hard disk drives.
Disk Array
The disk array controller board is a PCI board that improves data reliability. The disk
array controller board allows the hard disk drives in the SCSI or S-ATA hard disk drive
bays to support disk array configuration RAID levels 0, 1, and 5.
RAID is an acronym of "Redundant Arrays of Inexpensive (Independent) Disks". It
logically integrates several hard disks to appear to the system as only one disk drive.
Using the disk array method, the large-capacity hard disk can be configured with
several inexpensive and small-capacity hard disks. It can also enhance the drive by
improving the reliability and supporting an automatic rebuilding function.
All RAID levels are common in their basic operation due the fact that several hard
disks can be recognized as one disk drive. However, performance, cost, and use are
conditions that vary according to the RAID level. You should select an appropriate
configuration that is suitable for your system.
Features and selection examples of different RAID levels are shown below.
Level
Definition
RAID0
Striping
RAID1
Mirroring
(or shadowing)
RAID5
Striped data
and parity
This unit supports other RAID levels as well. However, it is not recommended to use
them unless absolutely necessary.
120Eg User Guide - System Overview
Table 1 - 1: RAID Levels
Redundancy
No
Access: high-speed.
Yes
Dual disk system.
Read mode: high-
Write mode: slower
than RAID 0
Yes
Parity data.
Transfers large
amount of data.
Write mode: slower
than RAID 0
1 - 18
Feature
Suitable
application
Application that
needs high
performance for
non-critical data
Application that
needs to store
important files
speed
on main system
drive
Application that
needs to store
important data.
Application of
read-intensive
type
data searching.
Minimum
No. of
disks
2
2
3
Advertisement
Table of Contents
