32
Connecting the Internal LTO to the Server
・Specified SAS cable is used for the Internal LTO connection.
The procedure for the installing the Internal LTO in a system is as follows.
Some servers require the rails to be used. For details on how to install the rails,
refer to the server's operating manual.
Remove the cover from the server.
1.
Install the Internal LTO as shown in the figure below, and fix with the screw which accessary of the Internal
2.
LTO.
For using device expansion unit, refer to its user manual.
When installing the Internal LTO, use the screw which accessary of the Internal
LTO. DO NOT use the screw in the accessory of device expansion unit.
Turn off the power before installing or removing the Internal LTO from the
server.
Always be sure to turn off the main power and unplug the power cord from the AC
outlet before installing/removing the Internal LTO or connecting any cables. There is
a risk of electric shock if the Internal LTO is installed or removed or any cables are
connected while the power cord is still plugged into an AC outlet.