Table of Contents
Advertisement
Cabling the Device
The IDE Cable
Depending on your configuration, your system may come with one or several three-
connector IDE interface cables.
Each IDE connector on the motherboard supports two devices.
The addition of a device to an IDE connector does not require the replacement of the
existing IDE cable.
The following figure shows a typical three-connector IDE cable. If the IDE cable is not
keyed with a connector tab, align the coloured edge (Pin 1) of the cable with the pin 1
side of the drive connector.
The S-ATA Cable
Depending on your configuration, your system may come equipped with a S-ATA
cable.
The following picture shows a S-ATA cable. Black side goes to hard disk drive; blue
side goes to motherboard.
120Eg User Guide - Upgrading Your System
A - Connects to the motherboard IDE port
B - Red edge (Pin 1)
C - Connects to IDE devices
Figure 4 - 38 : Three-connector IDE Cable
Figure 4 - 39 : S-ATA Cable
4 - 52
Advertisement
Table of Contents
