Table of Contents
Advertisement
Is BIOS configuration correct?
- The internal LAN controller may be disabled with the BIOS SETUP utility of
the server. Check the setting with the BIOS SETUP utility.
<Menus to check:
[Advanced] - [PCI Configuration] - [Onboard NIC1 (10/100/1000) / Onboard
NIC1 (10/100/1000) ROM]>
Have the protocol and service already configured?
- Install the distinctive network driver for the server. Make sure that the protocol,
such as TCP/IP, and services are properly specified.
Is the transfer speed correct?
- Open the network property dialog box in control panel to specify the "Link
Speed & Duplex" value the same as the value specified for HUB.
Problems with NEC EXPRESSBUILDER
When the server is not booted from the NEC EXPRESSBUILDER CD-ROM, check
the following:
Did you set the NEC EXPRESSBUILDER during POST and restart the server?
- If you do not set the NEC EXPRESSBUILDER during POST and restart the
server, an error message will appear or the OS will boot.
Is BIOS configuration correct?
- The boot device order may be specified with the BIOS SETUP utility of the
server. Use the BIOS SETUP utility to change the boot device order to boot the
system from the CD-ROM drive first.
<Menu to check: [Boot]>
Is an error message appeared?
- When an error occurs while the NEC EXPRESSBUILDER is in progress, the
following message appears. After this message appears, check the error and
take the appropriate corrective action according to the message listed in the
table below.
This machine is not supported.
NvRAM access error
Hard disk access error
120Eg User Guide - Problem Solving
Message
Cause and Remedy
This NEC EXPRESSBUILDER version is not
designed for this server. Execute the NEC
EXPRESSBUILDER on the compliant server.
An access to the nonvolatile memory
(NvRAM) is not acceptable.
The hard disk is not connected or it is failed.
Check whether the hard disk is correctly
connected.
5 - 27
Advertisement
Table of Contents
