Test The Registration Mark Sensor - GRAPHTEC FC8000 SERIES User Manual

10
Confirm the setting and press the POSITION (◄) key
(PREVIOUS).
D ETECTION THRESHOLD is selected and it will return to
DETECTION THRESHOLD adjusting screen.
11
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS setting screen (4/4).
12
Press the [MENU] key.
It will return to default screen.

Test the Registration Mark Sensor

If there still is a difference in the cutting, even after performing an
adjustment using the registration mark, it is possible to check if
there is a problem with the registration mark itself or the application
by evaluating the position of the registration mark plotted and
detected only using the plotter.
Operation
1
Print the standard registration mark in the accessory CD.
MARK TYPE 1
2
Load the printed media onto the plotter.
3
Press the [MENU] key.
MENU screen is displayed.
4
Press the [2] key (ARMS).
ARMS setting screen (1/4) is displayed.
Next page
MARK TYPE 2
5-21
POSITION
Supplement
It will return to ARMS setting screen (4/4) without
changing the settings when you press the
POSITION (◄) key (CANCEL).
CAUTION
This function performs cutting after the registration
mark is scanned. If a cutter is used as the tool, it
may harm the plotter.
Supplement
Print the "Test Pattern 1" to test MARK TYPE 1,
l
and "Test Pattern 2" to test MARK TYPE 2.
Standard registration mark is inside the "ARMS
l
Test Files" folder of the accessory CD.
Registration
Mark
MARK TYPE 1
MARK TYPE 2
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6 for loading the media.
File
File Name
Format
pdf ARMStest_type1.pdf
eps ARMStest_type1.eps
pdf ARMStest_type2.pdf
eps ARMStest_type2.eps