GRAPHTEC FC8000 SERIES User Manual page 144

14
Press the [2] key (NUMBER OF POINTS).
NUMBER OF POINTS setting screen is displayed.
15
Press the [1] key (2POINT), the [2] key (3POINT), or the [3] key
(4POINT).
POINTS is selected and it will return to MARK SCAN MODE screen.
16
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS setting screen (1/4).
17
Press the [MENU] key.
ARMS SETTING screen (1/4) is displayed.
18
Press the [2] key (MANUAL READ MARKS).
Following message is displayed.
19
Press the POSITION (▲▼◄►) key and move the tool to the
position of the adjustment mark specified by the message.
20
Confirm the position of the tool, and if it is OK, press the [ENTER]
key.
O nce all the adjustment marks are specified, DISTANCE entry screen is
displayed.
Next page
Supplement
It will return to MARK SCAN MODE screen
without changing the settings when you press the
POSITION (◄) key (CANCEL).
Supplement
It will return to ARMS setting screen (1/4) without
changing the settings when you press the
POSITION (◄) key (CANCEL).
Supplement
Tool carriage will move faster when the [FAST] key
is pressed simultaneously with the POSITION key.
POSITION
Supplement
Repeat steps 14 and 15 if following message
l
prompting to move to the adjustment mark is
displayed.
Number to repeat steps 14 and 15 differs
l
depending on the specified number of the
adjustment marks. Follow the message that is
displayed.
It will return to ARMS setting screen (1/4)
l
without scanning when the [4] key (CANCEL) is
pressed.
6-5