Adjusting For The Registration Mark Scan Position; Adjust After Plotting The Adjustment Registration Mark - GRAPHTEC FC8000 SERIES User Manual

Adjusting for the Registration Mark Scan Position

Sensor to scan the registration mark is positioned away from the tip of the tool (pen tip). Therefore, it is
necessary to adjust the coordinate values of the scanned registration mark so it will match with the cutting
position.
If the registration mark is already marked on the media, scan that registration mark, plot another registration
mark in the same position, and measure the difference between them. This difference is entered as a
adjustment value.
If there is no registration mark on the media, plot a registration mark first, scan that registration mark, plot
another registration mark, and measure the difference of them. This difference is entered as a adjustment value.
Reference
There is a restriction on the shape (style) of the registration marks that can be scanned. See "Setting Shape (Pattern) of Registration Mark"
P.5-9 .

Adjust After Plotting the Adjustment Registration Mark

This section describes the steps to plot the registration mark.
Registration mark is to be plotted if there is no registration mark on the media to adjust the registration mark
scan position. Then proceed to the steps of "Adjust the Registration Mark Position".
Reference
Proceed to "Setting the Position Using ARMS"
media.
Operation
1
Load white media.
2
Set the water-based fiber pen (black) on the tool holder.
3
Press the [MENU] key.
MENU screen is displayed.
4
Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
Next page
P.5-30 without plotting the registration mark if the registration mark is already drawn on the
5-24
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6 for loading white media.
Supplement
See "Attaching a Tool" P.2-4
water-based fiber pen.
for setting the