Setting The Reference Angle - GRAPHTEC FC8000 SERIES User Manual

7 -
3

Setting the Reference Angle

The FC8000 analyzes the cutting data, and controls the angle of the cutter blade tip if the change in the
angles of the corner is large.
Angle control is applied if there is larger angle change than the angle specified as reference angle.
The time to cut is shortened by setting large value for the reference angle, since it will only apply blade
control when there are angles with large angle change, hence reducing the time to make the blade control.
But, if it is set too large, there will be not enough angle control of the blade, and the cut result may differ
from what was expected. Set the reference angle in good balance.
Supplement
This setting is maintained even if the power is turned off.
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
3
Press the POSITION (▼) key.
TOOLS SETTING screen (2/3) is displayed.
4
Press the [1] key (OFFSET ANGLE).
OFFSET ANGLE setting screen is displayed.
Next page
POSITION
7-11