Copy (Duplicate Cutting) - GRAPHTEC FC8000 SERIES User Manual

4 -
2

Copy (Duplicate Cutting)

The function to cut specified numbers of cutting data stored in the buffer memory is called COPY.
Supplement
Do not send new data to plotter while copying. Cutting data in the buffer memory will be cleared.
l
Previous cutting data will be cleared and newly sent data will be stored as cutting data if you send new data with 10 seconds or more interval
l
from the time it finished cutting.
It can not copy if data is more than 1.6 MB because it cannot be stored in the buffer memory of the plotter.
l
Buffer memory that can be used for copy will decrease if you turn on the data sort. Turn off the data sort when you need to copy cutting with
l
large data. See "Sorting the Cutting Data"
Watch out that it does not fall out of media when cutting with copy function.
l
If the original cutting data to be copied starts away from the origin point, copied cutting will also start away from the origin point. To avoid
l
wasted space, create the cutting data close to the origin point.
Copy is performed in following order.
<For rear loading/sheet>
Origin point
First cut
It will copy in following order when MIRROR is set.
<For rear loading/sheet>
First cut
Origin point
P.8-2
for data sort.
Second copy Fourth copy
Copy space
Copy origin First copy Third copy
point
Copy origin point
First copy Third copy
Copy space
Second copy Fourth copy
Copy
space
Copy
space
4-9
Supplement
For the front loading model, rotate the above
figure 180 degrees.
Supplement
For the front loading model, rotate the above
figure 180 degrees.