GRAPHTEC FC8000 SERIES User Manual page 54

3
Press the [1] key.
CONDITION No. selection screen is displayed.
* Display may vary depending on the selected condition number.
4
Press the POSITION (▲▼) key and select the condition number
(CONDITION No.).
5
Confirm the setting and press the POSITION (◄) key
(PREVIOUS).
CONDITION No. will get set and return to TOOL setting screen.
6
Press the POSITION (▲▼) key, and set the tool.
7
Press the [3] key (OFFSET).
OFFSET setting screen is displayed.
* Display may vary depending on the selected condition number.
Next page
POSITION
POSITION
Supplement
POSITION
It will return to CONDITION screen without
l
changing the settings when you press the
POSITION (◄) key (CANCEL).
Tools that can be selected are as following:
l
CB09U, CB15U-K20-SP, CB15U, CB15UB,
CB15U-K30, OTHER, POUNCE, LIGHT
POINTER, PEN
Supplement
What is Offset
l
It will adjust the difference between the tip of the
blade in the plunger and the center of the plunger.
There are standard adjustment values for each
cutter blades. Fine adjustment will be made to that
standard values here. (Adjustment will be made
with standard value as 0.)
It is not necessary to set the offset if "Pen",
"Pouncing", or "Light Pointer" was selected in the
tool settings.
Guideline to Set Offset
l
Blade
material/
Ultra-hard
blade
Other*
* S et for the setting values not displayed in the
cutter blade type when cutting the media that is
hard to cut.
Guideline to Set Pouncing
l
material/tool
Pouncing
To return to continue the settings of other tool
l
condition number, return to step 3 by pressing
the [1] key.
2-27
Blade type Setting
range
tool
CB09U ± 5
CB15U-K20-SP ± 5
CB15U ± 5
CB15UB ± 5
CB15U-K30 ± 5
― 1 ~ 45
Blade Setting range
(intervals)
1 ~ 99
Setting
value for
OTHER
18
28
28
5
28
1
Setting
value for
OTHER
1