3
Press the media lock to engage it, and then pull the leading
edge out of the front of the plotter so that it completely covers
the media sensor.
4
Position the media and the push rollers to correspond with the
width of the media.
When the Media Width is 160 to 540 mm
Position the two right-hand push rollers when the plotter is viewed from the
front so that they are at the edges of the media. Make sure that the push rollers
are both positioned over grit rollers. Move any push rollers that are not used to
the standby position.
Media
Next page
Media sensor
Push roller
Push roller
Media
sensor
Grit roller
Media
lock
Raise
Supplement
The media must always be positioned over the
l
media sensor.
See "Aligning the Push Rollers"
l
about the position of the push rollers.
See "Standby the Push Roller"
l
the standby position.
2-7
P.2-13
P.2-13
about