GRAPHTEC FC8000 SERIES User Manual page 150

7
Press the [2] key (START).
Overcut length for START setting screen is displayed.
8
Press the POSITION (▲▼) key and increase or decrease the
setting value.
9
Confirm the setting value, and press the POSITION (◄) key
(PREVIOUS).
It will return to OVERCUT setting screen.
10
Press the [3] key (END).
Overcut length for END setting screen is displayed.
11
Press the POSITION (▲▼) key and increase or decrease the
setting value.
12
Confirm the setting value, and press the POSITION (◄) key
(PREVIOUS).
L ength for overcut END is selected and return to OVERCUT
setting screen.
13
Repeat steps 3 to 12 as necessary to set multiple tool
CONDITION No.
14
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (3/3).
15
Press the [CONDITION] key.
It will return to default screen.
Supplement
Setting range is from 0.0 mm to 0.9 mm.
POSITION
Supplement
Setting range is from 0.0 mm to 0.9 mm.
POSITION
POSITION
Supplement
It will return to CONDITION screen (3/3) without
changing the settings when you press the
POSITION (◄) key (CANCEL).
7-5