Table of Contents
Advertisement
3
Attach a media stocker to each of the left and right stand sides
with two socket head cap screws, using the Allen wrench. Mount
the media stockers so that each one protrudes directly above
the longer of the two base assembly lengths.
4
Mount the plotter on the stand by inserting the positioning pins
on the stand into the positioning holes on the underside of the
plotter. Fasten with four socket head cap screws (two on each
side), using the Allen wrench. The cutting plotter mounting
direction is different for the front loading and the rear loading
models.
Socket head
cap screw
Positioning pin hole
Caster stoppers
5
Tighten the socket head cap screws loosely fastened in Step 2.
Media stocker
Stand sides
<Front loading>
Socket head
cap screw
Positioning pin
Socket head cap screw
Media stocker
Base assembly
Supplement
Check that all of the screws used for fastening
l
have been tightened. The media may not be fed
correctly if even one of the screws is loose.
When installing the plotter, make sure that there
l
are no objects in its vicinity. Leave a clear space
of at least 300 mm around the plotter.
1-8
<Rear loading>
Advertisement
Table of Contents
Troubleshooting
