GRAPHTEC FC8000 SERIES User Manual page 136

2
Press the POSITION (▲▼◄►) key and move the tool carriage
to the area to start scanning of the registration mark.
MARK TYPE 1
Point
4
Point 1
(point to make
origin point)
Point
3
Mode the tool inside this
area
3
Confirm the position of the tool, and if it is OK, press the [ENTER]
key (SET).
R egistration marks are scanned automatically. DISTANCE entry screen is
displayed once the scanning is completed.
4
Press the POSITION (▲▼) key and increase or decrease the
setting value.
5
Confirm the setting and press the [ENTER] key (SET).
A djustment by scanning the registration mark is completed, and it will return
to default screen.
Registration mark scan area
Point
2
Mode the tool inside this
area
POSITION
MARK TYPE 2
Point
Point
2
4
Point 1
(point to make
origin point)
Point
3
POSITION
5-35
Supplement
Left figure is for 4POINTS. Size and position of the
registration scan start area is same for 2POINTS
or 3POINTS.
Supplement
Scan the registration marks in accordance
l
with the setting of the MARK DISTANCE (see
"Setting Mark Distance" P.5-12
It will return to ARMS setting screen (1/4)
l
without scanning when you press the [4] key
(CANCEL).
Supplement
Measured distance is displayed in the top line in
l
the DISTANCE input screen. Input value (initially
same as measured value) is displayed under
that.
If the input value is not changed, it will assume
l
that there is no difference between measured
distance and the distance in the data.
Digits of settings can be changed by pressing
l
the [FAST] key.
Supplement
It will return to ARMS setting screen (1/4)
l
without changing the settings when you press
the POSITION (◄) key (CANCEL).
Distance input screen for point 3 is displayed if
l
it is set to 3POINTS or more, so repeat steps 4
and 5 to set.
).