1 -
4
Connecting to the Computer
Connect the plotter to the computer using the interface cable. Use either the USB port, the network
(LAN) port, or the RS-232C port to connect the plotter to the computer. Select the port depending on the
specification of the software to be used and the availability of the interface port on the computer.
Depending on the port used, use either the USB cable, the network (LAN) cable (sold separately), or the RS-
232C cable (sold separately) to connect. Use the cables specified by Graphtec, matching the computer that
is to be connected.
The network (LAN) interface is a factory-installed option. It cannot be retrofitted.
Connection
1
Check that the power switch is turned off (the "u" side is
pressed down).
2
Connect the plotter to the computer using the interface cable.
Next page
Connection via USB interface
Connection via LAN interface
Supplement
See the "Setting Interface"
the interface.
Computer
USB cable
(supplied)
Computer
Network
hub
Network (LAN)
cable
(sold separately)
1-12
P.9-2
about setting