When The Media Width Exceeds 540 Mm - GRAPHTEC FC8000 SERIES User Manual

When the Media Width Exceeds 540 mm

Position the three right-hand push rollers when the plotter is viewed from the
front so that the left and right push rollers are at the edges and the middle
push roller in the center of the media. Make sure that the push rollers are both
positioned over grit rollers. Move any push rollers that are not used to the
standby position.
If you wish to use all four of the FC8000-160 push rollers, position the two
outermost push rollers at the edges of the media and the other two push rollers
in between, making sure that the push rollers are all spaced equally, and that
each push roller is positioned over a grit roller.
OK
5
Pull the media taut to make sure that there is no slack in the
conveyance path, and then raise the media set lever to lower
the push rollers. Release (lower) the media lock.
Push roller
Push roller
Push roller
Media
Grit
sensor
roller
Supplement
The media must always be positioned over the
l
media sensor.
See "Aligning the Push Rollers"
l
about the position of the push rollers.
See "Standby the Push Roller"
l
the standby position.
Lower
2-8
P.2-13
Media
lock
P.2-13
about